3 / 3
VWRBS3-SIP Series DC-DC Converter
Rev. 07-2007
- Input current
Application Notes:
Nominal input voltage range. The input
current of the power supply must be sufficient
to the startup current (Ip) of the DC/DC module
(Figure 2)
- All of the VWRBS3-SIP Series have been tested
according to the following recommended testing
circuit before leaving the factory. This series should
be tested under load(Figure 1). If you want to further
decrease the input/output ripple, you can increase
capacitance properly or choose capacitors with
low ESR. However, the capacitance should not be too
high(Table 2).
CS Capacitor T able(Table 1)
Vout
CS
5V
9V
12V 15V
24V
47uF-100uF
10uF-47uF
External Cap acitor T able(Table 2)
- Output Load
Vout
5
Cout (Max)
1000uF
680uF
In order to ensure the product operates
efficiently and reliably, make sure the specified range
of input voltage is not exceeded.
9
12
15
470uF
330uF
No parallel connection or plug and play.
Figure 1
Temperature Derating Graph
Operating Temp.( C )
- NC Terminals
Unless otherwise specified, NC terminals of all series
are used for converter's interior circuit
connection, and are not allowed connection of any
external circuit.;
- CTRL Terminal
When open or high impedance, the
converter will work well; When this pin is ‘high’; the
converter will shutdown; It should be noted that the
input current should remain between
5-10mA,exceeding the maximum 20mA will
cause permanent damage to the converter.
V-Infinity, LLC, 20050 SW 112th Ave., Tualatin, OR 97062
www.v-infinity.com
1-866-372-1258
